A recessed shelf is ideal for a small space, such as a narrow hallway or bathroom wall. Perfect for holding hair product bottles or decor accents, this shelf sits right in the wall so it doesn't protrude into the limited space of the room. While this project may seem like a job for a professional, you can bet that it's completely doable with the right tips and tools. Follow along with our instructions to check this weekend project off your to-do list.
Locate studs with a stud finder. Make an inspection hole to ensure your placement is not interfering with electrical, HVAC, or plumbing.
To do this, choose a small section (3 x 3 inches) of wall between studs where you want your shelf to go. Use a drywall saw to cut out a square while holding the saw at a 45-degree angle. (This will prevent the piece from falling into the wall.) Place a pocket-size mirror into the hole and use a flashlight to look for any obstructions in the way of where you want your recessed shelf to sit.
Measure how tall you'd like to make your shelf (we made ours 16 x 16 inches) and how high up you'd like it to be installed. Use the drywall saw to cut out drywall between studs, using a stud finder to be exact. Remove drywall and set aside.
Cut small sheet board and craft board to dimensions of interior shelf. This should include a back to the shelf, 4-inch-deep sides, and a 1- to 2-inch lip to go around the shelf. The lip frames should be cut at a 45-degree angle.
Begin by building the sides of the shelf. Position the side boards to form a square, and use two clamps to hold the structure together. With a pencil, make marks for two screws at each corner. Use a power drill to make pilot holes, followed by the screws.
Line the sides of the shelf with wood glue as shown above. Place the cut craft board directly on top of the box structure and press down. Let dry.
Once glue is dry, drill one screw in the middle of each side. First, measure and mark 3/8 inch from the edge. Drill pilot holes followed by screws. Set aside.
Use wood glue to press the corners of the shelf lip together. Let dry. Line the shelf structure with wood glue, and place the shelf lip directly on top. Press down and let dry. Use a hammer and finishing nails to secure the lip to the shelf as shown above. Use two nails per side.
Apply wood putty to all seams in the shelf using a flat putty knife. Let dry. Sand away excess putty until smooth and wipe with a clean cloth. The wood putty will dry to match the color of the wood and will help conceal the seams and holes made by the finishing nails. Stain and paint shelf, if desired.
Carefully place shelf into drywall hole. Attach shelf to wall studs by drilling pilot holes and screws into the sides of the shelf. There should be two screws on each stud-facing side.
Be the first to comment!