BHG.com  ∕  Topics  ∕  Home Improvement  ∕  Roofing  ∕  Eave
share

Eave

Find everything you need to know about Eave right here

Articles

Understanding Your Roof

Understanding Your Roof

overhanging roof edge is called the eave ; it is often covered on the parts of the roof near the eaves , a self-adhesive membrane flashing is designed for use at eaves and rakes (the ends of the roof). Usually the eave flashing is installed, then

Keeping Out Water

Keeping Out Water

then roofing cement. Eave and rake flashings make installed at the rake and the eaves . The best arrangement attach the drip edge at the eaves directly to the sheathing membrane) goes over the eaves flashing, then the drip firmly attached to the eave fascia and tucked under

Identifying Problems

Identifying Problems

they can crack. If you see ice collecting along your eaves , perhaps accompanied by long icicles, you likely snow on the roof can melt and trickle down to the eave . Because the eave is unheated, it freezes there, creating a dam. As

More Articles

Videos

Clever Kids' Room Storage

Clever Kids' Room Storage

Little ones have lots of stuff and need easy ways to store it. This room is built for fun and organization.

Thu, 5 Aug 2010|More from Kitchen Bath Ideas
|eavesfound at2:14

and daydream. To the right of the window seat, packed into the eaves of the home is the equivalent of a built-in dresser to hold folded clothes. The display front drawers more commonly used to

Slide Shows

Painting Soffits and Eaves

Painting Soffits and Eaves

Start the fun part of your painting project with the soffits and eaves .

2009 Home Improvement Challenge: Exterior Facelift Winner and More Favorites

2009 Home Improvement Challenge: Exterior Facelift Winner and More Favorites

reproduction, the new front porch features square columns resting on stone piers, deep eave overhangs, false beams, and a king's post truss support. Boxed eaves rather than the more historically correct exposed rafters gives the roofline a clean

Roofing Over Existing Shingles

Roofing Over Existing Shingles

the existing shingles at the eave end, as would be done for a flashing is installed at the eaves and rake to wrap around the roof clean as you work. At the eave and the rake, install U-shape for reroof jobs. Install the eave piece first, then the rake

Installing Pre-shingle Flashings

Installing Pre-shingle Flashings

type of drip edge as you used for the eave . Checklist Time 1 to 2 hours to cut extends beyond the drip edge at the eaves . If you saved the old valley flashing angle and make sure it neatly abuts the eave 's drip edge. Nail it in place with

Installing Roll Roofing

Installing Roll Roofing

roofing felt or primer, perhaps WSU for the eaves , roll roofing, nails long enough to poke pull it taut, and drive nails along the eave edge. The nails should be about 1 inch them flush with the drip edges along the eave and rake, and attach them by driving two

Applying Underlayment

Applying Underlayment

especially the part that overhangs the eaves and is susceptible to ice dams -- it is or roofing nails Apply drip edge to the eave . Cut drip edge flashing at an angle at the corner, press it lightly against the eave end (not too hard or you will misshape

More Slide Shows