Refine By
Forrest
$77.00
at Amazon

With this all purpose blade for tables saws you can rip and crosscut 1" - 2" rockhards and softwoods resulting in a smooth-as-sand...ed surface. With 20 DEG face hook, ply-veneers will crosscut with no bottom splinter at moderate feed rates. Double hard and 40% stronger C-4 carbide will give up to 300% longer life between sharpenings. Ends blade changing (one blade does rip, combo and crosscut). Ends second-step finishing. Ends cutting 1/16" oversize to allow for resurfacing. Buy and sharpen one blade instead of 3, (24T rip, 50T combination, 80T crosscut). read more

Forrest
$167.00
at Amazon

Designed for perfect, chip-free cuts on melamine and plywood, the Forrest Duraline Hi-A/T virtually eliminates the need for a scor...ing saw. The 40 degrees points slice through thin bottom layers with no tears or chips. Recommended for thin, low pressure, two-sided laminates, plywood and fine crosscutting on all woods. Made with double-hard C-4 submicron carbide for longer life between sharpenings. 10" x 80T, .125 kerf, 5/8" arbor hole read more

Forrest
$310.00
at Amazon

The Forrest NM1612011180 Circular Saw Blade is an all-purpose blade for table saws that leaves edges ready to use with minimal pla...ning and sanding. The Forest NM1612011180 Blade is double hard for a longer cutting life and made for cutting wood between 1 and 2 inches thick. read more

Forrest
$115.00
at Amazon

Forrest's blades offer a superior cut that leaves a rip-cut saw edge that is as smooth as if it had been sanded, and a cross-cut e...dge that is almost mark-free. The blades run very quietly, and backside tearout in plywood is negligible. Each blade is virtually hand-made. The plate is hand-tensioned (up to 15 minutes per blade), superior C-4 carbide teeth are hand-brazed to the plate, and the blade is straightened and restraightened multiple times throughout the process. Think of a Forrest blade as a tool in your shop, not an accessory. Forrest stands behind it's blades by offering a sharpening service that bring blades back to the exact tolerances offered in a new blade. And this same exacting service is available for other manufacturer's blades as well, so they should come back better than new. Forrest Woodworker 2 Saw Blade For Table Saws. With this one all purpose blade you can RIP & CROSSCUT 1' to 2' hardwood and softwood resulting in a smooth as sanded surface. Ply-veneers of oak and birch will crosscut with NO BOTTOM SPLINTER at moderate feed rates. Customized Forrest Woodworker 2 For Table Saws. For the advanced table saw operator. Ideal for joinery and special uses. Specially engineered clearances on the carbide teeth can totally eliminate side scoring. The result...no planing/jointing or sanding. In many cases a glue-line cut can be obtained, depending on the accuracy of the saw machine.20�� Face Hook for easy feedDOUBLE HARD and 40% STRONGER C-4 CARBIDE will give up to 300% longer life between sharpenings.Ends second-step finishing (jointing and sanding not required).Buy and sharpen ONE blade instead of 3, (24T Rip, 50T Combination, 80T Crosscut).Ends cutting 1/16' oversize to allow for RESURFACING read more

View wishlist Set Sale Alert Continue shopping
View Sale Alerts Continue shopping