The roof panels of the two wings
prop open.

More Components

• Three 1x10s, 37-1/2 inches long, for the roof arches (S)
• Two 2x4s, 97-1/2 inches long, for the base ends (T)
• Two 2x4s, 79-1/2 inches long, for the base sides (U)
• Four 1x2s, 75-1/4 inches long, for the posts (V)
• Two 1x4s, 82-1/2 inches long, for the beams (W)
• One 1x2, 77-1/4 inches long, for the door stop (X)
• Two 1x2s, 84 inches long, for the roof stringers (Y)
• Two 1x2s, 84 inches long, for the hinge mounts (Z)
• Four 1x2s, 38 inches long, for the braces (AA)
• Four 4-inch galvanized T-hinges (for door)
• One strap gate/door handle
• One galvanized sliding barrel latch (for door)
• 3-inch deck screws
• 1-inch deck screws
• Four curved lid supports
• No. 8 x 3/4-inch brass panhead wood screws
• Eight 1/8-inch acrylic panels, about 19 x 34 inches, for wing walls (cut size will be determined after frame assembly)
• Eight 1/8-inch acrylic panels, about 19 x 22 inches, for wing walls
• Eight 1/8-inch acrylic panels, about 27 x 34 inches, for sloped end panels
• Four 1/8-inch acrylic panels, about 29 x 39 inches, for wing roof assemblies
• One 1/8-inch acrylic panel, about 42 x 84 inches, for center roof
• Four 1/8-inch acrylic panels, about 20-1/2 x 33 inches, for front door and back panel
• Two 1/8-inch acrylic panels, about 25 x 33 inches, for front door and back panel
• Two bags of crushed rock
• 4-8 bags of concrete mix
• Four galvanized tie-down straps/ties
• Galvanized 4d finishing nails
• 3/8 x 3/8-inch square molding for acrylic stops
• 1/2 x 1-inch acrylic retainer strips