- view all thumbnails
After rolling out a pulp sheet, tear and press wet pieces onto varying sizes of foam balls; let dry.
TIP: Add paint (powdered or liquid) during the papermaking process to modify the paper color. (Papermaking instructions start on slide 7.)
Place a lampshade on its side on top of dry handmade paper. Roll the shade along the paper, tracing the top and bottom during one full rotation. Cut out the paper and use fabric glue to secure it to the shade. Glue on trim of your choice.
TIP: Recycle newspaper and discarded mail as ingredients in your paper, but avoid glossy paper; dull finishes produce a better result. (Papermaking instructions start on slide 7.)
TIP: Use embroidery hoops to craft a papermaking mold, stapling nylon screen from a home improvement store to the outside hoop. Use the inside hoop as a deckle. (Papermaking instructions start on slide 7.)
TIP: To help keep some inks from bleeding, add two teaspoons of sizing (from crafts stores), glue, or liquid starch after blending the paper ingredients. (Papermaking instructions start on slide 7.)
Paper (we used white copy paper and construction paper)
Dried flowers and herbs (optional)
Mold (a wooden frame with a screen on one side). Deckle and mold kits are available at crafts stores.
Deckle (a wooden frame without a screen)
Nylon screen the size of the mold
Cotton tea towels
Gather 1-1/2 times as much paper as the desired finished sheet size. Tear paper into 1-inch pieces.
Place half the pieces into the blender. Cover with 6 inches of water; blend.
Add the remaining paper and blend until the pulp is soft.
If you'd like, add dried flowers and herbs; this will give your paper a nice fragrance. Blend again.
Place the mold screen side up in a tub filled with 3 inches of water. Top the mold with the deckle and hold it down so the water rises to about 1 inch from the top. Pour the pulp into the deckle, using your free hand to evenly distribute the pulp over the screen.
Pick up the deckle and mold, tilting gently to allow excess water to drain. Remove the deckle so you're left with a layer of wet pulp on top of the mold screen. Place the unattached screen over the pulp.
Press a moist sponge over the screen to remove excess water. Squeeze the sponge and repeat as needed. Turn the mold over onto a damp tea towel and press the sponge on the mold screen until you're able to lift the mold off the sheet of pulp.
Flip the screen and pulp over on another tea towel and roll over the screen with a rolling pin, transferring the sheet of pulp to the towel. Carefully peel the screen from the pulp. Top the pulp with another tea towel and roll until it is nearly dry. Place the pulp sheet between two blotters, top with a heavy book, and let dry.
FULL YEAR just $5.99